Started by finishing the trailing edge.
Here is the trailing edge nice and straight.
So here is the left elevator almost done. It won't be done until the trim tab is done and the hinge is drilled to the left elevator.
Next I started on the trim tab servo I had to figure where the brackets go before drilling them in place.
This picture is to show the lines I used to layout the holes for the brackets.
Here is the servo I need to mount on the panel.
After reading the brackets I painted them.
Hey guess what the brackets are painted.
Hard to tell, but the servo is mounted.
Here are the rivets holding the brackets to the plate.
This is what the plate looks like in the elevator.
Just one and a half hours again today had lots of other things to do.
Type at ya next time.
Previous Home Next
Questions, Comments, Concerns Please E-Mail Me